NOW APPROVED BY THE DEPARTMENT FOR TRANSPORT (DFT)

The new PD 6500i is an airport style scanner, It utilises Garrett's exclusive digital signal processor (DSP) -based technology to provide superior target detection coverage on the left, centre and right side of the body from head to toe. Unique 33-zone pinpoint detection assures the ultimate in safety, throughput and reliability with pre-set programmes to cover the most complete range of security applications, including the new Transportation Security Administration's (TSA) Enhanced Metal Detector System required for all U.S. airports. Multi-dimensional coil design detects guns, knives and other flat and rod-shaped weapons regardless of archway location. Zone adjustment enables maximum detection regardless of environmental challenges. Easy-to view eye-level pacing lights with international wait and proceed symbols on the entrance side of each panel. Easy operation with back-lit LCD and LED bar graphs for continuous online operating status and self-diagnostic reporting. Features : A dual access non-resettable code to safeguard calibration settings. An audible alarm to reveal any unauthorised access attempts. Built-in overhead electronics compartment to eliminate the inconvenience of a cable-connected console. Multi-phase frequencies and variable tone settings to facilitate multi-unit operation. Modular electronics and unit design for easy on-site assembly and maintenance. 2 year warranty. Click on the PDF link for a more detailed outline of the PD6500i. The Garrett PD6500i can now be seen in most railway stations across the UK in association with the British Transport Police initiative to cut knife crime.

The PD 6500i is the world's highest performing walk-through metal detector and leads the industry with superior pinpoint technology and unmatched discrimination and sensitivity features. Designed for maximum patron throughput without compromising safety, the PDi is the walk-through of choice for security professionals worldwide.

The PD 6500i's Access Control Panel is designed for use by authorized personnel with specific, security codes. It allows authorized users to change settings such as detection Programme and Sensitivity. Security of the detector's settings is maintained with a non-resettable code, which indicates if an attempt has been made to change the settings by an unauthorized user. A tamper alarm sounds within 10 seconds after the Access Touchpad is pressed, unless the access code is entered.

The PD 6500i will retain all settings even when it has been turned off and back on again, this does not require a battery. While the unit is in operation, a self-test of all systems is performed continuously with any failures or problems immediately reported on the LCD display. Press operate at any time to run a self test on the archway.